TSS Limiter Pro v.3.5 Mini (included logger)
Limiter for ship models with online telemetry and logger
Price: €160
add to cartDescription
Version for Mini classes. It differs from the regular version only in the use of 13AWG power cable, instead of 10AWG as in the regular version. This version can only be used for Mini class models; long-term current should not exceed 40A.
The energy limiter for radio-controlled models (hereinafter the limiter) is intended for calculation and limitation of the energy consumed by the model.
The "PRO" version differs from the "LITE" version in the presence of a logger.
The device is equipped with the Bluetooth Low Energy (BLE) interface for communication with mobile devices or computers which allows to perform its settings and receive the current readings without need of having direct access to and its removing from the model.
The device can be used both for running the competitions to limit the energy consumed by the model from the accumulator and for training intentions to set the model and take the actual readings on current, voltage, energy and consumable battery capacity.
The device fully meets the Naviga requirements which allows using it in all kinds of registered or non-registered competitions according to Naviga rules. In event of rule changes, the new array of device settings will be available in new firmware upgrades of the device. The firmware upgrade is performed through the user`s phone, you need not send the device anywhere.
Technical specification
Parameter |
Value |
Note |
Measured voltage |
0 – 52V (12S) |
DC |
Voltage measurement accuracy |
±0.05% + ±5mV |
|
Measured current (up to 20 sec) |
1 – 150A |
|
Measured current (DC) |
1 – 100A |
|
Current measurement accuracy |
±0.25% + ±40mA |
|
Measured energy |
0 –
300,000Wh
|
|
Energy measurement accuracy |
±0.5% |
|
Sampling frequency |
10kHz |
|
Series resistance |
0.25mOhm |
|
Current consumption |
6mA |
|
BEC voltage |
4 – 8.4V |
|
Type of communication interface |
BLE |
Bluetooth Low Energy 5.0 |
Communication Interface range |
100m |
In direct visibility |
Receiver signal |
0.7 – 2.3ms |
Standard PPM 3.3-10V |
Working temperature range |
0 – 50⁰C |
|
IP rating |
IP67 |
|
Dimensions of the device |
22.5 х 19.5 х 10.5mm |
No wires included |
Weight |
16g |
Including all wires and plugs |
Wire to receiver length |
240mm |
|
Wire to ESC length |
40mm |
|
Type of signal wires |
26AWG (JR) |
|
Length of the power wire |
100mm |
|
Short description
In total, the device has 14 sets of settings, 8 (6 - 14) of which are user-defined and are subject to change.
The device has 6 sets of preset settings. These settings cannot be changed and 1 – 5 sets fully comply with the Naviga rules.